revision 1.1

by

Master X

(see the notes shown below this article before considering the use of a shocking device)

On one fine Saturday afternoon while strolling through a sporting-goods store you happen upon a display of electric dog training collars. You decide to stop for a moment and peruse them while at the same time trying not to look excited. It is at this juncture that what would be considered an inappropriate thought percolates up into your conscious awareness. "Humans are just more advanced animals, I wonder if one of these shock collars would work for training a slave?" The answer is yes and this article will cover the logistics and my experiences training a female slave with just such a collar.

I think using a shock collar for training a female slave is superior to other methods. Advantages of the shock collar include.

Proper selection of a shock collar for slave training, from among the many brands available on the market, is of paramount importance. Some brands and models will not work for training a female slave because of the way they are designed. Serious injury to your slave's delicate neck could result. Models and designs that fall into this dangerous category are ones that have shock prongs (the two metal electrodes that deliver the shock) that stick out like long sharp vampire teeth and cannot be properly modified to accommodate the slave's neck. Remember these collars were designed for dogs which have a protective coat of fur which of course your slave does not have. It is important to be mindful of this when selecting a shock collar.

Important guidelines to follow when selecting a shock collar that will be used for training your female slave include.

Below are three diagrams of shock collar units. Diagram one represents a type of unit that cannot be safely modified for slave training. In this type of unit the collar often goes around the outside of the shock module. The blue line in the diagram represents what I call the contact plane of the collar. The contact plane represents the contact surface of the collar if it was to lay flat across the slave's neck. In diagram one the electrodes and housing of the shock module extend beyond the contact plane (blue line) of the collar making it impossible to lay flat upon the slave's neck in any sort of safe comfortable manner. Therefore shock collars similar in design to diagram one should be avoided.

Diagram #1

Diagram two represents a different design of shock collar. The collar is held on to the shock module by the shock electrodes (in red) themselves. The shock electrodes are usually threaded studs that go through holes in the collar and thread into the shock module. Plastic spacers (in blue) are usually used to hold the collar firmly in place. In its current unaltered state the electrodes still extend too far past the collars contact surface plane but once modified this shock collar design can be safely used for slave training.

Diagram #2

Now we will modify the shock collar so that it can be safely used for slave training. The first step is to unthread and remove the electrodes represented in red in diagram two. Next remove the plastic spacers that hold the collar firmly to the shock module represented in blue in diagram two. Next remove the collar from the shock module. Next use a rectangular piece of foam to take the place of the original plastic spacers. Foam from a blue camping mat or other similar material can be used. This is represented by the blue in diagram three. Make sure the foam is the proper thickness. After placing the blue foam as a spacer put the collar back on the module. Next get some flat metal washers represented in green in diagram three. Make sure the washers are not so big that they touch each other. This would cause the negative and positive poles of the shock module too short out. The next step is to thread in Flathead Phillips machine screws, represented in red on diagram three, that have threads that match the threads of the original electrode studs. Now you have a shock collar with a much lower profile. The machine screws represented in red in diagram three will now act as the electrodes.

Diagram #3

You need to test the collar by putting it on your neck first before putting it on your slave, yes you heard me right. The reason is that on the adjustable shock level collars you have no idea how strong or weak the shock really is until you test it. Don't test it on your arm or leg because you will not get a real sense of how strong the shocks really are. Test it on your neck because the neck is much more sensitive and that is where the slave is going to have it. Put the collar on well enough for the shock electrodes to touch your neck. Set the level on the remote to the lowest setting first. Start walking around and suddenly press the quick shock button. Was the shock strong enough that it jolted you to attention and broke your train of thought? That’s the level you want. If you said to yourself, "How wimpy I can take that" it's not set high enough. Move the setting up a level or two and test again. You also don't want to set it too high. You are looking for a balance between too low and too high. This will become the shock level for training. After you have the training shock level figured out you can fine tune it once it's on your slave by going up or down one setting. The higher shock levels should be used for punishment and stopping recalcitrant behavior. You should have a collar that has both Quick shock (momentary) and Continuous shock modes. Quick shocks are used in training and Continuous shocks are used when your slave tests your resolve or for punishment.

An important aspect to using a shock collar is to be very disciplined when administering shocks. Don’t use the shock collar to inflict pain upon your slave just because it gives you the power to do so. Overusing or abusing the shock collar will destroy its effectiveness in the slave training process. You need the slave to trust your training ability and proper discipline when using the shock collar becomes a major focal point of this trust.

It is now time to fit the collar to the slave. Put the collar around her neck and fasten it loose enough where you can move the shock module around her neck easily. Get a feeling for where and how the module would lay on her neck. I prefer having the module on the front because it is not in the way of her pillow when she lies down in bed on her side. This may not be possible depending on her larynx and neck shape. Having the module on the side is the next best option and she will just have to get used to it. Don't have the module on the back of the neck as it will interfere with neck movement because of the bones back there. With your hand hold the module against her neck were you plan to have her wear it. Next fasten the collar on your slave. You only need the collar tight enough so that the flathead machine screw electrodes are always touching her neck no matter how she moves her head. You may find that the increments of the collar's holes aren't quite right. In one hole it is too loose and in the next hole the collar is too tight and digging in. You will either have to punch a new hole or get a different collar that the shock module will fit on. Stay away from leather because she is going to be wearing the collar 24/7 during the initial training process and this includes wearing it in the shower. Leather doesn't do well in water. All higher end shock collars are water proof.

Have her wear the collar for 30 minutes to an hour then take it off and check her neck for abrasion marks. If it is abrading it may be too loose and slipping around or too tight and digging in. Also check the area of her neck where the electrodes are contacting, make sure they are not digging in. The electrodes only need to touch. If she complains about the collar check her neck to make sure the collar isn't tearing her neck up. If everything seems fine have her wear the collar the rest of the day and check her neck again before bed. Then have her wear the collar overnight and take a shower in the morning while still wearing it. Check her neck one more time. Don’t be lax about this test period for the collar because she is going to be wearing it possibly a month or longer without ever taking it off. After the training period you don't want to take off the shock collar and find out her neck got all scarred up.

If her neck looks fine the next day it is now time to create a lock setup for the collar. The simplest way is to get a zip-tie and run it through two holes and across the tail end of the buckle and cinch it down. If you want a more elaborate setup take the collar off your slave and fasten the buckle in the same hole as it is worn on the slave. Take a leather punch and make a hole about an inch away from the buckle on the tail side of it. The punch will be passing through the collar material twice. Put the collar back on the slave while placing a flat based pin through the punched holes. Put a small luggage lock through the pin.

Now that the collar is fitted and locked on the slave you are ready to explain the rules and punishments to your slave. You also need to tell her that you may punish her in a manner that doesn't involve using the collar. You should already have your rules and slave modes worked out by this point. What you need to do is assign punishments to the rules and post them on the wall.

Here are some general guidelines.

During the initial excitement of the training your slave will probably be quite obedient. Once this initial excitement wears off and she sees that slavery is quite mundane get ready for her to test your resolve and the collar's shock ability. Your slave will most likely test your resolve within the first week of training. A few days into the initial training my slave decided to test my resolve. The first time my slave started being obstinate the shock came as quite a surprise as I turned the level up quite high and held the continuous shock button. At first she angrily tried to pull the collar off. When that didn't work she tried to act tough and bear it. Trying to hold out was pointlessly futile of her and within moments she broke down crying at which point I heard her say, "Master please stop I'll do what you want". At that point I released the button. It is important to stop the shock the moment proper behavior is elicited. I knew that she reached what I call the "turning-point" which is a nice euphemism for the point I psychologically broke her. I then had her apologize to me for her poor behavior. I then cuddled her for awhile which I feel is a good idea because this is a major point where she will bond with you and she needs reassurance that slavery was the right choice. After I held her for awhile I told her to go do what she was suppose to do. She went and did her chores without hesitation. It is at this point I owned her both physically and psychologically. The second time I had to use the continuous mode was when she was trying to be cute and manipulative with her womanly methods and did not heed my warning. This time she straitened up her act right away.

Having a signaling tone on your shock collar makes it much easier to manage and handle your slave. This feature is so important that I don't recommend getting a shock collar without a signaling tone. The signal tone is activated by pressing a button on the remote. The tone emits from the shock module on your slave's collar. My slave is trained to stop whatever she is doing when she hears the tone. One tone tells her to go to my bedroom, two tones go to my study, three tones go to the living room, four tones tells her to systematically search the house and grounds for me, and five tones tells her to prepare for sexual service and go to my bedroom. If she hears four tones but already knows where I am, excluding my bedroom, study, and living room, she is to go directly there.

Here are some scenarios so to get the idea of how useful this tone feature is.

You can of course setup your own system of signaling your slave and it may end up being superior to mine.

In my opinion using a shock collar is the fastest and most reliable way to condition and train a female slave for 24/7 service. I believe using a shock collar dramatically cuts down the overall training time because of its quick and reliable negative reinforcement. Don't forget it is also important to have positive reinforcers that reward your slave for proper behavior. Always keep safety in mind whenever implementing training techniques. Remember your female slave is your most valuable property. Just as you would not want to damage your television or automobile you don’t want to injure your female slave. If your slave is truly your most valuable property, as Master, you would give up your car or house before giving up or purposely injuring your female slave. Since time is the stuff life is made of, it is the most valuable resource we have. Your slave is literally giving her most valuable resource, her life, in complete devotion to her Master.

The End

B.E.S.T. slave training does not endorse or advocate  the use of a shock collar in the training of a slave. 

The choice is yours if you use one on your slave and the affects of its use on her is your responsibility.